Question 1

How long does hardwood floor installation take?

Accepted Answer

Room-scale hardwood installation can take a few days; refinishing often a couple of days plus cure time. Leveling, acclimation of the wood, and finish drying all add to the schedule.

Question 2

Do I need soundproofing under my new floors in NYC?

Accepted Answer

Many buildings require sound attenuation between units. An underlayment or sound-rated assembly is often required by code or building rules, especially for hard-surface floors.

Question 3

Can hardwood be refinished or does it need replacement?

Accepted Answer

Solid hardwood can usually be refinished multiple times if it is thick enough and not too damaged. Engineered wood has a thinner wear layer and fewer refinish cycles.

Question 4

What flooring is best for NYC apartments?

Accepted Answer

Engineered hardwood, large-format porcelain tile, and quality vinyl plank are common choices, balancing durability, sound control, and compatibility with building rules.

Question 5

How much does flooring installation cost?

Accepted Answer

Flooring costs depend on material, subfloor prep, and square footage. Hardwood refinishing is less than new installation, and commercial or stone flooring is at the higher end. A measured estimate is most accurate.

Question 6

What is an alteration agreement?

Accepted Answer

An alteration agreement is the building's contract governing renovations inside a unit. It sets out insurance requirements, deposits, permitted work hours, who is responsible for damage to shared spaces, and the conditions for restoring the building after construction. Your contractor usually coordinates the paperwork with the managing agent.

Question 7

What are typical renovation work hours in NYC buildings?

Accepted Answer

Construction in residential buildings is typically limited to weekdays — commonly 9am to 5pm — with no work on nights, weekends, or holidays unless the building and the Department of Buildings approve otherwise. Service elevators and loading schedules can further limit when materials can be moved.

Question 8

How much does renovation cost per square foot in NYC?

Accepted Answer

Quality renovation in New York City commonly runs well above the national average per square foot because of labor, logistics, permits, and building restrictions. Kitchens, bathrooms, and mechanical upgrades drive the total. A reliable budget always comes from a written estimate after an on-site walkthrough — conditions behind the walls often change the scope.

Question 9

Do brownstone and landmark renovations need special approval?

Accepted Answer

If a building is in a landmark district, exterior changes — including stoop work, window replacement, and facade alterations — require Landmarks Preservation Commission approval in addition to Department of Buildings permits. Interior work usually does not, unless the interior itself is landmarked.

Question 10

How are payments and deposits handled for NYC projects?

Accepted Answer

Most NYC contractors use milestone payments tied to construction progress — for example, a deposit to order materials, then payments at demolition, rough-in, and finish stages. Avoid paying the full cost up front, and make sure the payment schedule in the contract matches the milestones so you retain leverage until the job is complete.

Question 11

Do I need board approval to renovate my co-op or condo?

Accepted Answer

Most co-ops and many condos require a board-approved alteration agreement, insurance certificates, and often a refundable damage deposit before construction can begin. The building may also require work to be done by an approved contractor and within restricted hours.

Question 12

How long do Department of Buildings permits take in NYC?

Accepted Answer

Permit timelines vary by scope and filing type. Straightforward permit work can move in a few weeks, but filings that require professional certification, zoning review, or neighbors' notification can take longer. Board approvals in co-ops and condos add their own timeline on top of the DOB filing.

Question 13

What does a general contractor do in New York City?

Accepted Answer

A general contractor manages a construction project end to end — scope, trade coordination, permits, inspections, schedule, and budget — and is the single point of accountability for the build. In NYC that also means filing Department of Buildings paperwork, navigating co-op or condo board approvals, and coordinating work inside occupied buildings with limited access and strict hours.

Question 14

Do I need a sidewalk shed for exterior work?

Accepted Answer

Exterior work above a certain height or with any falling-object risk typically requires a sidewalk shed and Department of Buildings permits to protect pedestrians. Your contractor arranges the shed, permits, and any sidewalk-use permits with the Department of Transportation.

Question 15

Does New York City require a licensed general contractor?

Accepted Answer

For most permitted construction work, yes. A licensed contractor files the Department of Buildings permit and is legally responsible for the project. Unlicensed work on permit-required jobs can result in violations, stop-work orders, and difficulty obtaining a sign-off or certificate of occupancy.

Question 16

How do I verify a contractor's license in New York City?

Accepted Answer

Ask for the contractor's license number and insurance certificates, and confirm there are no open Department of Buildings violations against the firm or its principals. A reputable NYC general contractor will provide proof of licensing, general liability, and workers' compensation coverage before you sign a contract.

Question 17

Can I live in my apartment during a renovation?

Accepted Answer

It is possible for very small, well-contained projects, but most NYC renovations are easier and safer with the unit unoccupied. Dust, noise, water and power shutdowns, and the logistics of shared hallways make staying in place difficult for anything beyond minor cosmetic work.

Hardwood Floor Installation in New York City

About hardwood floor installation in NYC

What this work involves

NYC project considerations

Other flooring installation & renovation services

Hardwood Floor Installation — frequently asked questions

Find contractors for hardwood floor installation